Surface pieces (left) are glued to base (right), then foil is placed. This design involves removal of the protruding metal pins from both the Scalextric and Carrera ends meeting the connector. The steel wires are included to attract the magnet in the slot car and create "downforce". Cleaning Scalextric track. Light cleaning of the track surface is recommended for daily use. We recommend using a damp cloth or very lightly oiled cloth. This removes light grime and dust from the track surface. Wipe surface dry after using a damp cloth. This video shows you how to cut a 90 degree radius 2 piece of 2-lane Scalextric Sport track to make a single lane track, using basic tools.You'll need:TrackD We recommend using a damp cloth or very lightly oiled cloth. This removes light grime and dust from the track surface. Wipe surface dry after using a damp cloth. As matter of good practice, always do this before using the Scalextric layout as this will help ensure you get the best grip from the car tyres. Some sort of soft glue is probably best if you want to take up and redesign occasionally. Silicon or even hot glue would probably work. I have use very small Marklin train track screws but I would not recommend as some track damage occurs. Have not seen the trackclips but they sound good too. Regards Chas Le Breton. DVD3500. International Racer. Disconnect both track pieces (the track piece immediately before and after the fault). Turn them over on a hard surface. Ensure that the metal rail tabs at the ends of the rails (there are 8 of them on every track piece) are fully pressed and clamped down to the plastic. Use a stout screwdriver or similar to push them tight. GSsgz. Carrera add further options with 1:43 for their Go! Sets - this are an alternative to Scalextric Micro Sets and in our opinion are better value. The cars are larger, more detailed and the track layout typically more interesting. Carrera's standard scale is 1:32, so the same size as Scalextric. Carrera also offer an extra large 1:24 Scale Easy to fallow step by step process on how to build your own custom piece of Scalextric track. Special Thank You to Mike Landis for dreaming up this wonderfu I think the Scalextric barrier and clip packs are quite expensive to buy for what they are, or maybe I'm just being a cheapskate!. I like the idea of having the barriers closer to the track on some corners and straights without using the curb sections, I'm sure these would help with high speed spin offs too. FishyDelishy. If you run any digital track pieces then the best thing to do is level the track by putting either 2mm of card or something like laminate floor foam underlay under the 8mm analogue track. Then you can use 10mm foamboard at it will be flush. My new Scalextric Digital 9x5 Office Track with SSDC. Make sure your track is clean and connected properly. With movement or constant set up and take down, your track connections can become loose. PROBLEM: The track seems to only have power in one lane. SOLUTION: The problem could be with one of four things: a bad track connection, the controller, the terminal track, or the transformer.

how to clean scalextric track